Aug 2, 2021 · So I purchased some Barina T5 Led light bulbs (from amazon) and I am wanting to hardwire one of them for my work bench. I currently have a 20A outlet on the workbench as well as a 15A circuit that I was planning on hooking a switch to for said light.

Apr 6, 2018 · Have 48 led (2 Banks of 24) Shoplight with a standard AC plug into ceiling outlet, controlled by awall switch. Shoplight operated normally for the past year. And then, one day it didn't. It Powers ...

Feb 28, 2018 · I converted my shop to led from fluorescent.These are direct wire no ballast. Ran all new wires in conduit. The compressor is a 5hp single phase on a 60 amp breaker with 125amp main. I replaced compressor motor in 09. Compressor I installed in 1977 and has never given me a problem with the lights.

Apr 21, 2017 · My question is: can I wire two shop lights directly to the line source? In other words, can I wire nut 3 wires together (3 black, 3 white, 3 grounds)? Do I need to use the same type of light or can I use different kinds?

Apr 17, 2018 · Specifically, what ceiling box to use and would you mount LED light directly to joists or install something over joists then LED light. The pictures show the two areas that I will install LED lights. There used to be a hanging fluorescent shop light in first picture. In 2nd picture I am replacing the single chain light.

Aug 31, 2021 · I purchased a pair of plug-in LED shop lights. I've installed one light (everything works) but have a question about the ground. The original (hard wired) lights were in a metal case and the ground wire was attached to the case with a metal clip. The new LED lights don't even have a case, but a small plastic housing at each end.

I'm installing 3 LED shop lights in my basement workshop. I've already run new 12/2 NM-B wire to a few junctions and switches, per light. The attached picture is an example of the final splice I need to make. The cables that come out of the product (both need powered) are quite short and so don't lend themselves to being pulled into a junction box.

Dec 24, 2014 · LED emitters proper are very tiny. They must remain cool and are rather sensitive to overheat. Your LED-based light bulb has a big heat sink to remove heat from the emitter proper. Heat moves through a heat sink proportional to the difference in temperature. So as the air around the heat sink gets warmer, the heat sink loses effectiveness.

Sep 3, 2018 · If you enjoy kitbashing lights, real, actual fluorescent is the place to be. There's nothing cooler than taking a 1954 fluorescent fixture off Craigslist that's tough like it's out of a Navy ship, little sanding, some rattle-can white, slap a T8 programmed start ballast and 90CRI tubes, and suddenly it's magnificent ...

Feb 10, 2023 · There are many wiring configurations for LED retrofit tubes, so a definitive answer about necessity to replace sockets is difficult without knowing what the needs for the particular product are. The only clearly safe configuration with those sockets are SEP (single end power) lamps because you could power the opposite end and leave that end as ...